Description: Size: 20.0*33.5*6.0mm Weight:2.5g (including Futaba SFHSS compatible 7CH receiver by serial port output) Frequency for driving motor:2k (the frequency can be set up by user， max frequency can be 32K) Brushed ESC: continuous working current is 4.2A， max current is 6A(5S); Integrated with DCDC voltage booster circuit( output 5.0V/500Ma)， it can supply power for other device through IIC and UART port; The hardware of the FC is based on Naze 32， test firmware is cleanflight Naze V1.9.0 and V1.8.1.
Package Include: 1 x Brushed Flight Control Board (Built-in Futaba SFHSS Compatible RX)
SPECS: Power Requirement: 3.6 - 8.5V Current drain: 60mA max Delay: S.BUS mode:13.6ms CPPM mode: 20.4ms Sensitivity: -95dBm approx. Output mode: S.Bus or CPPM optional Channel #: 8ch Dimension: L*W*H=33mm*14mm*3mm Weight: 3g
Features: • Smooth and linear throttle control • Fast response to throttle input • Arm Cortex-M0 MCU • Stalled motor protection • Throttle signal lose protection • Safe power-on (throttle lockout) • Support 480Hz high refresh rates Specs: Constant Current: 30A Input Voltage: 2-4 cell LiPoly BEC: No BEC (OPTO) MCU: Arm Cortex-M0 PCB Size: 28 x 14 x 5mm Weight: 9g
Features: -Support 1-2S Lipo Battery -BB2， 48MHZ Chip -Blheli_S Firmware -Super small size and light weight -Support Oneshot42 Oneshot125 Multishot 16.42 D-shot -All codes use damped light mode.Damped light does regenerative braking， causing very fast motor retardation， and inherently also does active freewheeling
- The FIRST and ONLY 20X20mm platform micro flight controller with F3 chip - The FIRST and ONLY micro flight controller with PDB built-in - Heavy Duty 2A BEC @ 5V Output Built-in - LC filter Built-in - Built In Buzzer - Gold Plated Pads for the Very Best Connectivity - Firmware Perfection via CleanFlight & BetaFlight - Sbus Ready w/ Built In Inverter - FrSky Telemetry， Ready & Waiting - Full USB Support - Mounting Simplicity via 3mm Screws - Ultra Compact Design for Ease of Installation
Features: The worlds first F3_EVO controller compatible for DSM2. Cleanflight ready， acro flight controller for the BeeDuctrix / Tiny Whoop / Inductrix quad! Full Cleanflight/Betaflight compatibility on a STM32 F303 F3_EVO 3x1 style processor. Fully programmable through Cleanflight / Betalfight using the onboard USB port! Tune all the parameters， PIDs， and rates to your perfect settings! High discharge battery connector wire for more power and performance. Compatible with Spectrum/JR (DSM2 protocol) DEVO10/DEVO 7E (with deviation firmware). Can fly your Inductrix style quad in full rate mode (or even air mode!)， fully execute flips/ rolls， and shoot the smallest of gaps with precision! Tuned to provide that locked in feeling you get with standard size race quads.
·Latest EFM8BB2 mcu with 48MHz high-speed ·Three-Phase mosfet driver with hardware Synchronous rectification ·BLHeli_S firmware with Dshot600 supported ·235uF high capacitance ceramic capacitors ·2~4S power input ， no BEC ·2048 steps PWM resolution with control signal EN/PWM ·Continuous current 20A / peak current 30A ·Twisted-pair signal cable ·Ultra-small dimension: 24 x 13 x 3.6mm ·Weight: 4.43g (include cable)